16. CHAPTER XVI.
RADICAL CHANGES BEING MADE.
Changes, many of them extremely radical in their nature,
are continually being made by prominent aviators,
and particularly those who have won the greatest amount
of success. Wonderful as the results have been few of
Sectional View of New Wright Machine.
[Description: Black and white illustration: diagram of aeroplane.]
Among the men who have been thus experimenting are the Wright Brothers, who last year (1909) brought
Dimensions of 1908 Machine.
The 1908 model aeroplane was 40 by 29 feet over all. The carrying surfaces, that is, the two aerocurves, were 40 by 6 feet, having a parabolical curve of one in twelve. With about 70 square feet of surface in the rudders, the total surface given was about 550 square feet. The engine, which is the invention of the Wright brothers, weighed, approximately, 200 pounds, and gave about 25 horsepower at 1,400 revolutions per minute. The total weight of the aeroplane, exclusive of passenger, but inclusive of engine, was about 1,150 pounds. This result showed a lift of a fraction over 2 1/4 pounds to the square foot of carrying surface. The speed desired was 40 miles an hour, but the machine was found to make only a scant 39 miles an hour. The upright struts were about 7/8-inch thick, the skids, 2 1/2 by 1 1/4 inches thick.
Dimensions of 1909 Machine.
The 1909 aeroplane was built primarily for greater speed, and relatively heavier; to be less at the mercy of the wind. This result was obtained as follows: The aerocurves, or carrying surfaces, were reduced in dimensions from 40 by 6 feet to 36 by 5 1/2 feet, the curve remaining the same, one in twelve. The upright struts were cut from seven-eighths inch to five-eighths inch, and the skids from two and one-half by one and one-quarter to two and one-quarter by one and three-eighths inches. This result shows that there were some 81 square feet of carrying surface missing over that of last year's model. and some 25 pounds loss of weight. Relatively,
Some of the Results Obtained.
Reducing the carrying surfaces from 6 to 5 1/2 feet
Outline of Santos-Dumont's Monoplane as Seen From Above
[Description: Black and white illustration: monoplane from above.]
In the 1909 aeroplane, shortening the curve 6 inches at the parabolic end of the curve took off 1 inch of head-on resistance. Shortening the spread of the planes took off between 3 and 4 square feet of head-on resistance. Add to this the total of 7 square feet, less curve surface and about 1 square foot, less wire and woodwork resistance, and we have a grand total of, approximately, 12 square feet of less "head-on" resistance over the 1908 model.
Changes in Engine Action.
The engine used in 1909 was the same one used in 1908, though some minor changes were made as improvements; for instance, a make and break spark was used, and a nine-tooth, instead of a ten-tooth magneto gear-wheel was used. This increased the engine revolutions per minute from 1,200 to 1,400, and the propeller revolutions per minute from 350 to 371, giving a propeller thrust of, approximately, 170 foot pounds instead of 153, as was had last year.
More Speed and Same Capacity.
One unsatisfactory feature of the 1909 model over that of 1908, apparently, was the lack of inherent lateral stability. This was caused by the lesser surface and lesser extent of curvatures at the portions of the aeroplane which were warped. This defect did not show so plainly after Mr. Orville Wright had become fully proficient in the handling of the new machine, and with skillful management, the 1909 model aeroplane will be
To sum up: The aeroplane used in 1909 was 25
pounds lighter, but really about 150 pounds heavier in
Side View of Santos-Dumont's Monoplane.
[Description: Black and white illustration: monoplane from side.]
Front View of Santos-Dumont Monoplane.
[Description: Black and white illustration: monoplane from front.]
During the first few flights it was plainly demonstrated that it would need the highest skill to properly handle the aeroplane, as first one end and then the other would dip and strike the ground, and either tear the canvas or slew the aeroplane around and break a skid.
Wrights Adopt Wheeled Gears.
In still another important respect the Wrights, so far as the output of one of their companies goes, have made a radical change. All the aeroplanes turned out by the Deutsch Wright Gesellschaft, according to the German publication, Automobil-Welt, will hereafter be equipped with wheeled running gears and tails. The plan of this new machine is shown in the illustration on page 145. The wheels are three in number, and are attached one to each of the two skids, just under the front edge of the planes, and one forward of these, attached to a cross-member. It is asserted that with these wheels the teaching of purchasers to operate the machines is much simplified, as the beginners can make short flights on their own account without using the starting derrick.
This is a big concession for the Wrights to make, as they have hitherto adhered stoutly to the skid gear. While it is true they do not control the German company producing their aeroplanes, yet the nature of their connection with the enterprise is such that it may be taken for granted no radical changes in construction would be made without their approval and consent.
Only Three Dangerous Rivals.
Official trials with the 1909 model smashed many records and leave the Wright brothers with only three dangerous rivals in the field, and with basic patents which cover the curve, warp and wing-tip devices found on all the other makes of aeroplanes. These three rivals are the Curtiss and Voisin biplane type and the Bleriot monoplane pattern.
The Bleriot monoplane is probably the most dangerous rival, as this make of machine has a record of 54 miles per hour, has crossed the English channel, and has lifted two passengers besides the operator. The latest
La Demoiselle, Santos-Dumont's Smallest Monoplane.
[Description: Black and white photograph: A line of onlookers view monoplane.]Other Aviators at Work.
The Wrights, however, are not alone in their efforts to promote the efficiency of the flying machine. Other competent inventive aviators, notably Curtiss, Voisin, Bleriot and Farman, are close after them. The Wrights, as stated, have a marked advantage in the possession of patents covering surface plane devices which have thus far been found indispensable in flying machine construction. Numerous law suits growing out of alleged infringements of these patents have been started, and others are threatened. What effect these actions will have in deterring aviators in general from proceeding with their experiments remains to be seen.
In the meantime the four men named—Curtiss, Voisin, Bleriot and Farman—are going ahead regardless of consequences, and the inventive genius of each is so strong that it is reasonable to expect some remarkable developments in the near future.
Smallest of Flying Machines.
To Santos Dumont must be given the credit of producing the smallest practical flying machine yet constructed. True, he has done nothing remarkable with it in the line of speed, but he has demonstrated the fact that a large supporting surface is not an essential feature.
This machine is named "La Demoiselle." It is a monoplane of the dihedral type, with a main plane on each
Position of Motor on Brauner-Smith Machine.
[Description: Black and white photograph: Man in flying machine with motor in back]The framework is of bamboo, strengthened and held taut with wire guys.
Have One Rule in Mind.
In this struggle for mastery in flying machine efficiency all the contestants keep one rule in mind, and this is:
"The carrying capacity of an aeroplane is governed by the peripheral curve of its carrying surfaces, plus the speed; and the speed is governed by the thrust of the propellers, less the `head-on' resistance."
Their ideas as to the proper means of approaching the proposition may, and undoubtedly are, at variance, but the one rule in solving the problem of obtaining the greatest carrying capacity combined with the greatest speed, obtains in all instances.